|
If it's not blinking when you'r not pulling the trigger, then tighten the switch activation screw until you hear a click. After that, the imp should not be blinking if you're not pulling the trigger or holding it in. this is because the switch is activated. After that, loosen that screw just a little bit so that it starts blinking again. Then tighten the screw that is in the middle of the trigger. The one that determines how far of a pull you will have. Adjust that until it is pretty short, but still not too short so that the switch is always activated.
get it? lol.
__________________
[CENTER][IMG]http://pic14.picturetrail.com/VOL533/3257352/6663276/89920367.jpg[/IMG]
[SIZE="1"][B][URL=http://www.pbnation.com/showthread.php?s=&threadid=1066296]Trust [ 48+ / 0- ][/URL]
[URL=http://www.*******.com/xpizzerx]PiZpace[/URL][/B][/Center][/SIZE]
|