Here is a place to discuss anything about the pneumatic modifications (and hopefully in the future, upgrades) for mags. Pneumatic triggers have ben a concept and have been real for some time, but in the past year or so, theres been lots of interest in someone mass producing a factory made bolt on upgrade for mags. Its been shown that these guys[triggers] can pump out some 20+bps, and even my own garage-made hand dremeled mod has a sub 1mm pull.
As you can tell from reading this post, theres a lot going on today about who is making a pneumag frame, who gets to make it, who should make it, and who's fault it is that it never happened.
Lets try to be a bit more civil, folks.
Long live TK
Automags.org - Pneumatic Mag Walthrough*Warning, this takes you out of PBF and to AO. Conduct yourselves in a respectable way if posting on other forums.*
I fugured we could do with a sticky. I'm sure myself or RRFireblade (who is working with PTP to develop a drop in pneumatic trigger.) can answer any questions.
I'm working on my own personal model right now.
Here I've mounted the MSV-1 (which is a micro limit valve. You push the pin, and the circuit of air is connected). Note the absence of a trigger and length of the nail I'm usign as the pin. Today (6/30) I ground down the nail and have it the way it will be permanently.
It is under a 1mm trigger pull. I will get an actual figure tomorrow (with updated pics).
I did do a short movie which I probably will edit in the coming days.
So post away