Originally Posted by DR3XX

OK, if i upgrade my TES...i need some help on the t board and ramping chip and t-chip multimode.

for the t-board...i think it's only LED. is there anyway i can use my stock LCD screen on the t-board?http://www.scenariodreams.com/productpages/tes.htm

ok the t board is led only there is no way to get the stock lcd to work with the t board im sorry

the ramping chip, im not exactly sure what ramping is...can someone just tell me what this chip will do?http://www.scenariodreams.com/produc...mping_chip.htm

thoes chips ramping and t chip are for different board softwear, iinstead of having to buy a new board to get better softwear scenariodreams has made an upgrade chip that can be installed in your current tboard

for the t-hip multimode, i think this is better, but im not sure. the reactive trigger i think is 1 shot pull and 1 shot release of trigger.http://www.scenariodreams.com/produc...agun_tchip.htm

yes reactive means 1 shot on the pull 1 on the release,

for the chips, im i only able to choose one? if so, which ones better?

no u can buy both chips and just install which ever one you need for the day i havent been keeping up on the tboard so i have no clue which is better the modes a mentioned on the site just buy the chip that meets your needs


what i mean is that chip can be pulled out and replaced with either the t chip or ramping chip

also, is a new regulator necessary? i think the stock one is fine...
another thing,where do i change the velocity at??

well a new reg isnt needed as there is ways to get the stock reg to be verry highflowing and pretty damn good consistency with verry few lil mods sutch as drilling out the input hole on the reg piston and a simple rearangeing on the reg disks. also to adjust velocity u up the psi on the reg. dont go above 400 psi. if you do there is so much pressure pushing against the cup seal that the striker cant open the valve enough to get a good fps. if ur having trouble getting a good velocity with a psi set above 350psi then try a hard main spring so it hits the valve harded and will dump more air into the breach