evolkers2003

Here is some common problems and how to fix them:

Q: My fusion will not fire when my eyes are on:
A: 1. There is no ball in the breech.
2. Broken paint inside
3. Dirty eyes


Q: The pressure gauge will not move on my fusion.
A: The gauge is broken. Either it got hit hard, or you over pressurized the gun and broke it. Buy a new one.


Q: My fusion will not fire
A: 1. Turn the gun on
2. FIll your air tank and make sure the on/off is on.
3. Replace battery
4. Re-adjust trigger so its farther out.
5. Make sure your eye sensor is working, and there is paint in the breech if its on.
6. Adjust your pressure in your regs. Adjust the lpr if your OPR is set at 250.


Q: My fusion wont even turn on!
A: 1. Hold down button longer
2. The battery has come unconnected, or the battery wire is coming off. Either re-conect the battery or re-attach the battery cable.


Q: My fusion is leaking from the barrel
A: 1. Your valve pin is in the incorrect position. Remove the lpr and re-grease the spring and valve pin.
2. Your valve pin is worn and need to be replaced.


Q: My fusion is chopping paint.
A: 1. You need new ball detents.
2. Change battery
3. Make sure the eyes are clean.
4. Pressure is set too high in one of the regs


Q: My fusion wont cycle
A: 1. Your air pressure might be low. Re-fill your air tank, or adjust pressure in the regs.
2. Replace battery
3. Replace striker o-ring, or if it still persists replace the whole striker.

__________________

Sex on tv cant hurt unless you fall off.