|
The BL Torpedo is typically listed with an output range of 0-500psi. Usually, you run a reg at least 100psi from the high/low limits. Actually, BL's Intimidator manual says 200-300psi, which I assume is for the Torpedo. You'd need a new valve/valve pin to use the Torpedo, most likely.
I use an Ergo-reg on my Imagine and older Autococker. The Imagine runs in the 325psi neighborhood (valve and pin) and the Autococker at just under 400psi. Using the same reg, my nefew's near-stock (Spud bolt/Assault Block) Imagine runs no lower than 600psi.
My newer Autococker runs at about 225psi with a Stabilizer on HPA. I used it at a much higher pressure with my old Autococker on CO2 and it regulated well both ways. The Stabilizer is excellent at any pressure and gas. If you can swing it, do it.
__________________
God gave you a soul.
Your parents, a body.
Your country, a rifle.
Keep all of them clean.
|