JaKE kOjeSki

this is the idea of streetrider1137. he made it up and i just saw it and posted it here on painballforum

NOTE: these hopper mods only work for open bolt blowbacks[I.E. spyder, rebel, viewloader esspecially tippmanns due to side cocking]

version 1.) (((materials needed))) this one is REALLY simple, just drill about 4 holes into your hopper feedneck, just make sure the holes arent cooverd by the guns feedneck

Reason for faster loading-) the co2 or nitrogen relased into feed tube, escapes quicker leting the ball drop faster

version 2.) (((Materials needed))) Rubber band

drill or dremil

string

marble

STep one) put cut in rubber band so it is not continous

Step two) drill two holes into the marble, make sure that 1 is vertical and the other is horizontal

Step three) drill a hole in the top of your loader, make sure its in the center

Step four) drill hole in back of loader, prefferibly right under the lid

Step five) drill hole on opposite side of back hole

Step six) drill a hole right be hind the feedneck, facing up

step seven) drop rubberband through top hole and tie a not at top

Step eight) tie string to marble

Step nine) put rubber band thorugh marble hole, and tie knot at bottom in order to keep marble suspended

step ten) put string through marble, and put knot in string right before marble, and after it goes through the marble

step eleven) put sring through back hole, and tie string to cocking rod on gun and your done if this seems confusing at any point, IM me and il answer your questions