yeah, its fairly simple.
Your E-Force trigger frame is connected by 2 screws right? right.
unscrew them both and take the trigger frame off the gun.
ones its off look inside it and you should be able to see a chip/board/ looks like a hi-tech computer device.
the board will be connected by 2 little screws, one on each side of the board and it will also have a plastic cover which prevents paint and dirty from getting into the board.
now once both those screws are out, gentelly lift up the side of the board which is on the far end of the trigger frame ( the side thats closer to the barrel when the trigger frame is on)
now, at this point you have to be pretty gental or you can damage the board.
slowly lift up the board until you can see the bottom of it.
now, there should be a switch. flip it to the opposite side that its on.
BUT BE CAREFUL WITH THE BOARD, DO NOT USE FORCE WITH IT.
now put the board back into place and screw it back.
put the trigger frame back on and your tournament ready.
EDIT: OH MY GOD DYNASTYfan07, WHILE I WAS TYPING MY REPLY YOU ALREADY ANSWERED. THATS NOT FAIR!!!!
