|
Couple things to add:
The stock main regs are not lubbed a bit from the factory. It is a good idea to take it apart carefully, and lube it up good with some dow33 also...You will notice much better consistancy at the chono. The stock is not all that bad with HPA, its rather good actually, once its lubbed up and broken in properly.
It is possible to remove the trigger switch without the noid. I do not advise taking the noid apart, if you do, watch carefully for any orings or stuff that might fall out, its a very tiny part...
The stock trigger IS adjustable. Take your trigger frame off the gun, and insert the smallest allen wrench in the hole on the top of your tigger, and tighten it until the pull is just right for you.
__________________
Evil Dragun The One, Blue/Black
Evil Pipe Kit, Evil Timmy ASA + Detonator + Respirator, 50g trig, Clamping Feed, Delrin Timmy Bolt, CP Pro Rail w/CP on/off ASA, QEV, Halo-B, 3A 68/4500.
Black 2k3 Vision Impulse
CP Barrel Kit, Cricket Board, Centerflag Hyperflow Reg, Evil Hammer, NDZ Valve, Palmer Micro Rock LPR, E-Blade Trigger, Sure Fit LOW Rise Clamping Feed, Black Evil Delrin Bolt.
Green/Black Black Magic Autococker
Freak kit, 04 Orracle internals + Front Block, QEV's, Flame Hinge.
|