Once in a while yuo see people wonderinwhat to do with their spyder to keep it clean and working efficiantly.Here is how
Today i will be showing you with my spyder electra.
First I will show you how to take out the bolt. Remove the little metal pin holding in the bigger pin that my fingers are holding be sliding it over the bigger pin.
Once you have done that place it where you can find it again and then push through this bigger pin that my finger is on.But make sure to keep your finger on the back of the gun or the back part will fly across the room.
Now take out everything in this picture, it will look slightly different if you have a rear cocking or top cocking bolt.Remember not to lose a little metal disk that goes under the spring adn the black piece that is in the spring.
After you have done that take out your cocking bolt that my finger is on.It may be hard but dont worry about braking it just keep pullin as long as your doin it right.
Now you will be able to pull out the bolt and a black rubber circular thing and the striker will come with it.
Before doing anything else clean all paint off the bolt and inside the marker.
Now that you have done this take the bolt and put a thin line of oil down the side of it and spread the oil all over the bolt and then do the same thing with the striker.
And the last thing you do is to oil where th co2 goes adn put the co2 in and shoot a few shots.This will oil all your internals.If you have a reg then you dont want to oil the asa, remember that!.
Now do everything in reverse, make sure to put the little black piece in the bottom hole after you have put the bolt and striker back in, some people get confused on where this goes on theyre marker.
Then put the back on put the pin in and your all set.
And thats how to maintain your Kingman spyder marker.