That what i'v been thinking. You and nicad spent years and alot of money into this, and everyone else it just makeing to work, not perform like it can.
All the info in this thread just hits ya like a brick, eh?
I just drilled my actuator. Third time's kinda the charm. Tehres seriously gotta be a better way of doing this.
I snapped my drill bit after I caught a burr. I mean I had the cordless drill on low torque, and it was on a very low rpm. I caught a burr, so I flipped it on reverse, started to back out, the thing twisted even more and the bit just snapped!
Tomorrow I'm making a home depot run.
I kinda got the hole tapped (its a bit crooked becuase the bit went crazy on me). The QEV is mounted, but its not too strong. I'm hoping some red loctite, possibly even epoxy will do the trickfor a seal. I wont be going over 40PSI so it should be no biggie.
Stared the hackjob on teh riv-nut, and broke a dremel fitting. I had no way to hacksaw it becuase if I clamp it down, the clamp bends the riv-nut. I tried stickign the screw into it, and it just messed up teh threads. Its only a .30 piece...
Got a job interview at BostonPB on Monday, so I'm quite pumped over getting my mag ready, thsi new job and all sorts of stuff.
And just to get this across, I already talked to Shawn and I know you deleted a bunch of stuff, but cool it on the patent debate. I'm not going to delete it because there was no flaming, and theres tons of great info in there, but it was getting warm in here.
We have an all new warning and banning system, and I'm not afraid to use it.
And just to get this across, I already talked to Shawn and I know you deleted a bunch of stuff, but cool it on the patent debate. I'm not going to delete it because there was no flaming, and theres tons of great info in there, but it was getting warm in here.
We have an all new warning and banning system, and I'm not afraid to use it.
<3
Are you talking to me?
I deleted nothing so I'm assuming your talking about someone else in this thread then?
I'll assume the same on the threat of banning then as well or you need to be more specific about your accusations.
Where do you see that? I see that he says that if you vote yes you will be contacted for preferance for preorder when that time comes . Am I lookin at the wrong thread? Or does it say it somewhere else?
Can some one private msg me where i can buy the parts tom make a pneumag?
i would like ot start the project asap on my classic mag
aslo i would like ot buy an x valve and a chimera frame
some one plz help me out
AS far as getting the parts, clippard has the ram were using, and it depends on the 3 way you want. There is a three way that clippard sells, as well as one supplied by another manufacturer.
A warning, clippards shipping is high on small orders. Go over to automags.org and see if theres a group buy of any kind going on.
Xvalve's and chimera frames are much easier to procure in there B/S/T btw, it should be a simple matter to get it.
__________________
Proudest member of the Fightin Texas Aggie class of 08 Beat the h*** outa tu A Whoop!!!!.
If you need help, IM me. I'm around alot of the time and will answer questions happily . *Driftcav03*
Official PBF Pneu-Mag thread
. *Driftcav03*
