Denzil

Hey guys, it's actually been a while since I posted in these forums but I think I need a confirmation on a small issue before I go purchasing a new HPA tank. I'm converting my Spyder to a low-pressure setup and I want to know if I should go with a high pressure or low pressure tank?

I'm most likely going to stick with a PE, Crossfire, or Java tank. I have the Palmer's Stabilizer and I'm going to buy the low-pressure spring kit for it. I just want to reassure myself that I can use a high-pressure tank and use my low-pressure Stabilizer to set the psi manually to a low pressure around the 300psi range.

So what's the 411?

__________________
Planet Eclipse Ego 6 gun metal
Low Pressure Spyder Imagine blacked out

My PBF feedback : +2 / -0
My PBN feedback : +2 / -0
My eBay feedback : +32 / -0

Nor*Tex

well considering how your converting 2 low pressure u can use a low pressure tank... but you mite as well stay with high, the reg will lower it down to the needed psi

__________________

OSU

Denzil

Yeah I figured I'd be ok with getting a high pressure 45/4500 while using my Stabilizer to adjust the output through the gun. Stabilizer claims to adjust 0-800psi so I'm going to have to tune it to see if I can get my desired psi. This will determine if I really need that low-pressure kit from Palmer's or if I should just buy the Fatty Stabilizer.

__________________
Planet Eclipse Ego 6 gun metal
Low Pressure Spyder Imagine blacked out

My PBF feedback : +2 / -0
My PBN feedback : +2 / -0
My eBay feedback : +32 / -0

splatwithhonor3

You're going to need more than a reg and spring kit to get anywhere near 300psi.
1.New bolt
2.New valve
3.Polished internals (mainly striker)
4.Barrel with no porting on the rear 1/2-2/3

__________________
If you ever want to make something stop existing, the Milwaukee Sawzall is the tool.

Denzil

Uh yeah, I'm aware of that. I've done my research via Otter's. I'm just trying to clarify the issue between the pressure leaving the tank and going into the Stabilizer. I realize that the pressure leaving the tank must be slightly more than what the Stabilizer is limiting at so that the Stabilizer is being choked of psi due to the tank itself.

__________________
Planet Eclipse Ego 6 gun metal
Low Pressure Spyder Imagine blacked out

My PBF feedback : +2 / -0
My PBN feedback : +2 / -0
My eBay feedback : +32 / -0

sick_dawg

The pressure coming out of the HP compressed air systems is about the same as what the co2 is on average. You will be fine with a high pressure tank and will be able to use it on just about any gun you get.

__________________

splatwithhonor3

Just making sure you knew.
I <3 otter.

__________________
If you ever want to make something stop existing, the Milwaukee Sawzall is the tool.