Thread Tools

**pigstick** · June 13th, 12:00 AM

I was wondering if the part that screws into your marker, and is connected to the co2 tank is screwed into the tank or kept in some other way.
I noticed it moved a little bit when I was unscrewing it, and didn't know if it should be moving when I unscrewed it.
If it is screwed in, should I put some lock tite or something in it to keep it from moving?
Is the little bolt in it used to keep it from moving?

**paintballer05** · June 13th, 10:52 AM

thats not good you should get your tank checked out.

**jonnythan** · June 13th, 11:13 AM

It's screwed in, but take it to your local shop. They know what they're doing.

**pigstick** · June 13th, 11:50 AM

Should I empty it out first? It has about half a tank left in it. Or should I just let them empty it out?

**paintballer05** · June 13th, 02:30 PM

it doesn't matter. you can or they will

**paintbug** · June 13th, 09:52 PM

tank that tank to a pro shop ASAP!! there has been too many fatal accidents caused by poorly installed valves lately! if you dont have one close by let me know.

**pigstick** · June 13th, 10:09 PM

I'm taking it tomorow, It wasn't open today. Any idea of what they'll charge me to fix it?

**pigstick** · June 13th, 10:14 PM

Also, It's pretty new. Don't they come ready to shoot? Or do you have to put the lock tite in yourself? I've only shot it about 5 times.
I was wondering this, because I ordered another co2 tank from the same place I got this one. Is there a way to check them to make sure they're tight without accidentally breaking the lock-tite?

**paintbug** · June 14th, 09:37 AM

for some reason certain tank manufacures think that putting just an oring and not putting thread lock on the valve will hold. it is very unsafe and i have stated my opinion in several emails to them! sometimes they put loc-tite on them but not enough or they dont have the valve torqued down all the way when the make the tank. this would make the valve come loose more easily. you local shop may charge you $10-$20 if you didnt get it from them. i know we charge $20 per hour with a 1/2 hour minimum.

**pigstick** · June 14th, 12:20 PM

Wow, I'd think they'd come ready to shoot. I got a 20 oz pmi pure energy co2 tank by the way.

**paintbug** · June 14th, 12:52 PM

i figured you would have

. they are one of the companies i have sent emails too. they also got one from me about the fact they now put 3000 psi burst disk in their tank valves. CO2 are pressure rated at 3000 psi but they wont withstand that much substained pressure long. not to mention the damage it would do to a marker if 3000 psi went into it.

**pigstick** · June 14th, 01:46 PM

Jeez, they should at least put a warning. As far as I can remember, I didn't get any papers with it at all.

**pigstick** · June 14th, 03:08 PM

Well, I went there, and the guy said alot of times, lock tite can make it even worse, so torquing it all the way down is the way to go.

**paintballer05** · June 14th, 03:33 PM

did he fix it or does he still have it at the shop?

**pigstick** · June 14th, 04:43 PM

It's at the shop, I'll be picking it up wednesday.

Thread Tools

View more Paintball photos