Thread Tools

**noob824** · June 17th, 09:47 PM

i just got my co2 tank filled for the first time, cus i just got my bone daddy and i was going to try it out, so i started skrewing it in and it just started hissing like crazy, i tried skrewin it in tighter but it kept going so i took it off...so i then checked the o-ring again, and it was fine, nothing wrong with it...yesterday i was at my friends house and i used his co2 tank with it and it was fine...maybe theres sumtin wrong with the tank, i dunno...

**paintbug** · June 17th, 10:19 PM

sounds like the pin on your tank may be a little long. try putting in a tank oring into the ASA (where the tank goes) should take care of the problem.

**noob824** · June 18th, 10:38 AM

should i just put it all the way to the top of the asa?

**djj1973** · June 18th, 10:48 AM

Yes put it in flat the o-ring will act like a spacer.

**noob824** · June 18th, 11:02 AM

so have you ever had this problem before?

**nightstalker88** · June 18th, 11:04 AM

i think that mayb wats up with my tippy, i had that problem too

**¤COLD¤** · June 19th, 08:26 AM

sometimes also the o-ring may look mine but still needs to be replaced

**Roadkill** · June 19th, 02:48 PM

That happened to mee too, it turned a patch on my pants white with frost. I quickly unscrewed it. I decided to try it again, but i did it carefully and made sure i was screwing it in straight, and then it was fine.

**nightstalker88** · June 19th, 03:03 PM

actually i tried stikin an o ring in there and it worked fine

Thread Tools

View more Paintball photos