Thread Tools

**No1TubaPlayer** · February 20th, 04:37 PM

1. take out cocking rod by turning counterclockwise.

2. insert 3/16 allen wrench into hole where cocking rod was (IVG)

3. turn clockwise to raise velocity, turn counterclockwise to lower velocity

4. take out allen wrench

5. insert cocking rod

6. chrono marker

7. repeat if necessary

clockwise = the way a clock turns
counterclockwise = the opposite way of a clock

keep in mind that 1/4 turn of the allen wrench yields apprx. a 30 FPS change.

Grey - Back Block
Green - Bolt
Purple - Cocking Rod
Red - IVG Access Hole
Blue - Pull Pin

**2fingertrigger** · February 20th, 04:42 PM

sticky this thread immediatly

**No1TubaPlayer** · February 20th, 04:48 PM

Quote:

Originally Posted by 2fingertrigger

sticky this thread immediatly

word

**Master of Paint** · February 20th, 04:55 PM

Its not gonna get its own sticky, but I've added it into mine, and gave proper credit. Nice.

**Boomer_Sniper** · February 20th, 05:08 PM

good indeed

**No1TubaPlayer** · February 20th, 05:26 PM

swell

thanks for the add master of paint

**MP11** · February 20th, 05:35 PM

It would be great if you described what you were doing so they understand what they are doing, like I did here.

-Mike

**sumsimpleracer** · February 20th, 07:38 PM

you forgot one thing.....

Sweet spot your reg :P

**KidPaintball** · February 20th, 07:58 PM

Can't you just adjust the reg pressure and make it easyer?

**sumsimpleracer** · February 20th, 08:06 PM

alright...first off you should always Sweetspot your reg and never mess with it again
Because if the Reg was low and the IVG was high then your gun will be very inefficient

If the Reg was High and the IVG was low then your losing more air then you need to

If the Reg was High and the IVG was High thats REALLY high velocity

If the Reg was Low and the IVG was low thats REALLY low velocity

So if you sweetspot your reg and get your IVG where it needs to be then you'll be shooting a consistent velocity with efficient gas

**tippmannfronter** · February 21st, 07:21 PM

Nice post bro. Should be a sticky.

**sumsimpleracer** · February 21st, 08:07 PM

Quote:

Originally Posted by No1TubaPlayer

keep in mind that 1/4 turn of the allen wrench yields apprx. a 30 FPS change.

That would actually depend on the strength of the Main Spring

A red spring would probably be 30 FPS while a Yellow spring might be like 10 FPS

Thread Tools

View more Paintball photos