Thread Tools

**666paintballer** · February 27th, 05:32 PM

ya, so i finally got all the parts on my gun. the only thing is, i dont really know the correct way to set the lpr or how to tell when its set correctly, etc.
any help appreciated, thanx

**dirtrider** · February 27th, 05:34 PM

EDIT: NM, I thought u had a mechanical. I do not know how to set the elctros. On a mech u hold in the trigger and see how much the bolt clears the breech. Once the bolt clears the breech you give it just another quarter turn for comfort.

**3mag5num7** · February 28th, 07:07 PM

Turn your pressure all the way down til it won't cock when you pull the trigger then slowly turn it up (clockwise) til you can fire your desired rate without any recocking problems. Word of caution, don't turn it up too high or you'll end up blowing your solenoid.

**666paintballer** · February 28th, 07:19 PM

/\thanx alot
just to make sure
out=lower
in=higher?

**3mag5num7** · February 28th, 07:23 PM

Correct. Clockwise = higher. Counter-clockwise = lower.

**666paintballer** · March 1st, 11:25 AM

/\ thanx

**jaggy13** · March 1st, 11:33 AM

hey 666, keep in mind that some LPRs are setup "backwards" belsales for example is the oposite of the norm. I am not familiar w/ the black sonic LPR, so I would suggest that you leave the hose off the noid to test it. install the LPR, unscrew all the way (which should be 0psi) then add air. slowly turn it in (clockwise) until you hear air coming out of the pnuematic line. You can actually turn it back down and install the line then sweet spot it.

I would just hate to see you blow your noid.
to sweet spot it, turn the blade on, make sure you have good battery. start to shoot the gun and turn up the pressure until it shoots normally, then add 1/4 turn.

Thread Tools

View more Paintball photos