doja221980

I'm having serious issues with my breach sensor. Even if a ball is in the chamber, the gun doesn't cycle completly. The bolt stays cocked back like it's waiting for a ball to drop down and then after like 2 or 3 seconds it closes. I tried changing the sensitivity of the eye but no matter what I set it at (10%-90%) when the bolt is cocked back it reads 74 and when either the bolt is closed or there's a ball in the chamber it reads 94. WTF?!

666paintballer

your eye could be broken

__________________

doja221980

the sensor works. it changes when there's a ball in the chamber and when the chamber is empty. It just doesn't want to cycle completly.

toXic

maybe a loose wire in it somewhere or a short in a wire.

__________________

doja221980

if there was a short would the eye be dead completely or would the indicator change just a little bit (73 when the chamber is empty and 93 when there is a ball in the chamber)
thanks for the post by the way.

MP11

What color paint are you using? If it is anything dark that could be the problem.

-Mike

__________________

Fubar2

clean the eye. take that top screw out, take a q tip and brush it off, there could be junk in the way making it **** up. should do this any way every 4 - 5 times you use the cocker.

if its not that then i duno.

__________________

doja221980

I was using orange paint and I cleaned the eye before I used it last.

when you keep the sensitivity of the eye on 50% in the menu...how low is that top number supposed to be when there's nothing in the chamber?