nolife88

i decided to get a freeflow bolt for my autococker today, but after i re-assembled it the gun would have difficulty cocking, and was unable to un cock, using just the solenoid, no air. im afraid to gas it up, risking further problems. i figure its a problem with the hammer, but im unsure of what to do to fix it. thanks for any help you can give.

__________________

Autococker owner # 186

WGP Superstock
16 inch barrel with All American front and Freak back
WGP twist lock feedneck
FreeFlow valve
Empire Reloader II Hopper
Pure Energy 45/45 hpa tank
NXe bottle cover

RB

Correct me if im wrong, but when you replace a bolt, all you have to to is pull the pin, slide out the old one, and slide in the new one?

Ive been out of cockers for a while, but im pretty sure thats how its done.

__________________

Stroked and Sprayed '94 Fobra

txaggie08

yeah thats all there is to it.


sounds like something went south besides the bolt. Try a new batt, you may be low and the noids nto hitting hard enough. Also make shure everything is screwed in properly of course.....

__________________
Proudest member of the Fightin Texas Aggie class of 08 Beat the h*** outa tu A Whoop!!!!.

If you need help, IM me. I'm around alot of the time and will answer questions happily . *Driftcav03*

RL timmy FS ultra cheap

nolife88

im a dumbass, i got a freeflow valve, not bolt, my bad. and i got it fixed, brought the hammer lug thing up about three full turns, under supervision of my shop guy. the thing works now, dryfired and all that stuff, ill test with paint to make sure the eye thing still works, but other than that its all good. ill test efficiency, hopefully this weekend when im supposed to play, im hoping for at least a thousand shots off my 45/45, i only got like 750 max before. you guys have one of those valves? you like them?

__________________

Autococker owner # 186

WGP Superstock
16 inch barrel with All American front and Freak back
WGP twist lock feedneck
FreeFlow valve
Empire Reloader II Hopper
Pure Energy 45/45 hpa tank
NXe bottle cover

toXic

I would think you should back out the hammer a little bit. Using the hole behind the feed neck just twist it a couple times like your going to take it out, but just give it a turn and try to shoot it again.

__________________