SFLSHOOTER

I have a 2000 or 2001 Shocktech SFL cocker. I pull the trigger and the gun cylcles but does not shoot the ball. Does anyone know whats wrong? My guess is the the sear is shot.

jaggy13

sounds like the lug is set too low. If its been a while since you've used it, you may want to just re time the marker.

check out the sticky for step by step instructions.

__________________
MY FEEDBACK


1 cheap ION and one not so cheap ION

Don't Get Scammed! Use My 3rd Party Service!

SFLSHOOTER

i found the lug with my allen wrench and it will not turn, so i took off my grip frame and looked at the lug it is rounded, is that ok? and how hard should that lug be to turn?

__________________
Cocker Owner #196


Shocktech SFL Cocker

jaggy13

some lugs are rounded. its to reduce the break over tension on the sear. (make the trigger pull a little lighter and smoother.)

The lug may be lock tited in. if it still won't budge take the trigger frame off again (if not still off) and hit it with some heat. (lighter, pencil tourch.)
if you hear it start to sizle or see bubbles, thats enough heat. (10 seconds then try to turn it again)

__________________
MY FEEDBACK


1 cheap ION and one not so cheap ION

Don't Get Scammed! Use My 3rd Party Service!

thechubbss12

Ehh may seem stupid... but training mode?...

__________________
Revenge is a pleasure of the weak minded.

Those who justify who we hate have lost thier right to live.

http://www.spyder.tv/forums/showthread.php?t=1831 <----FEEDBACK
http://www.angelowners.com/showthrea...278#post513278

SFLSHOOTER

whats training mode?

__________________
Cocker Owner #196


Shocktech SFL Cocker

SFLSHOOTER

i also looked into getting a new hammer, but i would want to replace it with the "stock one" the shocktech Phat hammer, and i noticed that it has a nylon set screw to keep the lug form moving(i found this out at the shocktech site), so is that why may lug wont budge, but on the same note if im having this much trouble forcing it then how could it of become out of place, the last time i used the gun was like in early 2004 and it started acting up toward the end of the day and now it is horrible, do i need to pull the hammer out?

__________________
Cocker Owner #196


Shocktech SFL Cocker

jaggy13

this is a mech cocker...

training mode is a mode on the e2 trigger frame that doesn't allow the sear to trip.

You will have to move the lug to take the hammer out. otherwise it wount allow the hammer to move past the sear slot in the bottom tube.

__________________
MY FEEDBACK


1 cheap ION and one not so cheap ION

Don't Get Scammed! Use My 3rd Party Service!

SFLSHOOTER

yes it a mech cocker with a slide trigger, its old school

__________________
Cocker Owner #196


Shocktech SFL Cocker