zazzn

Hi All,

I have a 99 Cold fusion Ebladed cocker, that I have been using for years. It needs some maintenance now but I'm not sure where to find parts since it's so old!

Does anyone know where I can get a Pre 2k bolt and pin (Delerin please)

Can I just upgrade the back plate to make it a 2k+ cocker? or what is needed?

I'd also like to know if there is a way to fix the Ebalde from draining the battery while the gun is off is that even fixable? It's annoying as hell...

Thanks,

tlmiller

Yes, just get a whole new 2K+ backblock, bolt, and pin. If it's a standard body (I'm not sure what the cold fusions looked like), then any 2K+ will fit right on without issue.

Only way to fix the battery drain is to either hook up something that prevents the battery from touching the contacts or get a board, either the E2 or Yakuza.

__________________

Zidane

You can put a 2k+ back block and such on it, but Cold Fusions are rare and worth a lot of money so I'd keep it as stock as possible. Also, 99 cockers have different threading for the front block, so you can't fully convert it over.

Your absolute best bet for finding old autococker parts is buying them used on forums like mcarterbrown.com and Custom Cockers - Home

__________________
Kyle

VSC Phantom / Full CCM'd (AT) 2k3 Sniper / 2k5'd 2K2 Timmy
DivineWind
Proudly sponsored by:

tlmiller

Not just different threading, it's a whole different sized banjo bolt from 99 to 2000. Technically you can have the front block retapped if you'd want to, but it's way too expensive for the minor gains it can give you.

__________________