Thread Tools

**LuckXIII** · October 29th, 10:55 PM

I always used tape on my reloader to make a tighter fit on the oversized 2k3 feedneck, I was wondering what specfic if any clamps/necks that i can put on? theres so many when i look online and i cant tell what can and cant fit on my gun if any fits at all

**DayoftheGreek** · October 30th, 11:20 AM

Nope, the 2k3 feednecks cannot be replaced. Your stuck with that one forever. Unless of course you want to dish out the cash to get the old one chopped off and get a threaded one milled into it, but that expensive. Easiest thing to do is just keep using duct/asking tape. :-/

**lbreevesii** · October 30th, 12:27 PM

yup. exactly. you can send it in to docs or someplace, but it will cost you a pretty penny. if you do want to get it done, a clamping ccm is a good way to go.

**tippmannbeast** · November 1st, 08:57 PM

Use black electrical tape- it doesn't move and wobble like duct tape. Tip: stretch it as you put it on so it's a tighter fit.

**imstillsnless** · November 5th, 07:22 PM

wait, can the 2k4 feedneck be replaced?

**ZoWnX** · November 7th, 05:38 PM

or the 2k2?

**tippmannbeast** · November 7th, 05:51 PM

WGP models withOUT removable feednecks:
-all vert feed/right feed basic models from the begining, to 2004. (i don't know about the 05's)
-OutKasts

so pretty much just orracles. (as far as i know)

Thread Tools

View more Paintball photos