HeadyNugz

OK, so I have the 50g switch and the magnets to do the trigger mods. I'm also gonna sand down the trigger to a blade. But I can not get the damn trigger pin out of the frame. I used a thin enough nail and a hammer but the damn pin wouldn't budge. The friggin nail was actually bending.

If anyone have any suggestions they would be much appreciated. 0?

matt9119

ok first i would use a mallet. I use a vice and put three layers of cloth on it and let the pin drop but look on both sides. One should have like eched stars and one should be smooth(on the sides of the pin) no take a small object I used a dulled nail driver to put min through but it can only go so far so after youve got it out enough get some plyers and pull it out. should work the same for the switch. and if your trying to put magnets on the e-99 it wont work there isnt enough space between the trigger and the frame I allready tryed but you can try but im just letn you know a head of time.

__________________
Clear To Cobalt DM4
Empire Reloader B Blue

HeadyNugz

I Just Tried Again And The God Damn Thing Didnt Even Budge. I Ended Up Breakin A Damn Alan Wrench In The Process
This Is Starting To Royaly Piss Me Off!

matt9119

hmm then your prolly doing it on the wrong side cause one side has like ridges to keep it from budging and only a small portion on the the whole bolt is like that and if your hitting on that side then your trying to drag that end through the smooth side which isnt good preventing it from moving if you try the other side hit it hard and it will move vise versa try it

__________________
Clear To Cobalt DM4
Empire Reloader B Blue

HeadyNugz

Got It Out