Thread Tools

**[^_^x]** · September 18th, 04:42 PM

meh its ok the first one is the better one anyways. the second one is just a bunch of clicks.

**not_falling** · September 18th, 09:14 PM

j/w? Can you do the same thing to the tes to unlock those modes? Someone else asked this but no one replied.

**[^_^x]** · September 18th, 09:39 PM

im pretty sure its the same. Ill look into it tho.

**not_falling** · September 18th, 09:49 PM

ok, thx a lot! I was thinking that also, because the triggers they use in t1 and tes are pretty much the same, electronically.

**not_falling** · September 18th, 10:51 PM

ok, I just looked at my tes and there appears to already be a connection from the first inlet to the third one. It is brand new so it has to be factory.

**Tex** · September 19th, 04:34 PM

I edited my first post and incorporated some of the main points of this thread. Thanks to StealthRT, [^_^x], and all the other people on this dragun forum...
more to come later...

**not_falling** · September 19th, 10:20 PM

Ok, I pretty much get where all the wires go on unlocking the tes modes, except for where the solenoid one goes. There are 2 blue wires going to the very top input part in the second board. Does that stay there or does it move to the very bottom inlet?

Edit: N/M i found out, just keep it in the same one. Ok the modes are nice but i do like having the eye, so i changed it.

**Hobo_Joe** · September 20th, 02:06 AM

Tnx Tex, the more thats in the first post the better.

**Christian** · October 6th, 01:07 AM

stuck.

**Hobo_Joe** · October 6th, 01:35 AM

Thanks Christian,

I am surprised that you havene been asked to sticky this one earler as this is a VERY helpful thread.

Thanks again

**blank879** · October 6th, 11:16 AM

hey it says i can unlock these modes on a tes. i thought it wouldnt work??

**Hobo_Joe** · October 6th, 12:05 PM

Yip you can.. this is y this needed to be stickyied

**blank879** · October 6th, 12:07 PM

i read it and it doesnt really say how? or does it and im not comprehending

**Tex** · October 6th, 12:15 PM

Thanks for stickying it, Admins.

**blank879** · October 6th, 11:08 PM

someone help me pls

**jordin** · October 6th, 11:27 PM

im guessing there is no way of unlocking tise modes on a tes huu?

**Hobo_Joe** · October 7th, 12:59 AM

Exactly as it says do it for the T1.... the jumper from hole 1 to 3 and remove the eye board to get it to work like it should

**blank879** · October 7th, 08:30 AM

the diode is already in 1 and 3.

**jordin** · October 7th, 02:47 PM

i know that is what i am saying if you take it out then it will only go to simi and not auto

**blank879** · October 7th, 02:55 PM

maybe dragun like half way did it. im gonna try takin out the eye board tomorrow and see what happens.