dirtrider54

So I was playing paintball and my gun was shotting fine tehn all fo the sudden it started uncocking so I kept recocking it then shooting it and the max amount of shots was 3 then the 4th would roll out so I took the bolt out and was looking through there and the orings were allright all except the little black ring on the bottom bolt it was off a little. so I put it back on and it was dry shooting fine without balls but then it started happening agian and I dont know whats going on I dont have that much time to wrok on it since school has started so I Havent really payed attention to it for awhile so I was just wandering if you guys have any suggestions for if I get some time. my gun is a dragun tes thx

__________________
Orange to black 2k2 intimidator with ups

HK ARMY 4 LIFE

Hobo_Joe

Dude seriosly, use punctuation. It makes it easyer for us to understand.

I think I get what you are saying... ur best bet would be to wait for 20bps_tes he will understand and give you a solution.

Oh, and what u mean you dont have time? Use ur home work time!!! Then first thing in the morning, find the cleaver kid's and copy thier h/work!!

__________________
Marker = Dragun "The One". #19

=-if you followed these instructions you do so at your own risk, Hobo_Joe, the author takes no responsability for your stupidity in listening to ppl on the internet

Please rate my T1

20bps_tes

OK make sure ur gun is nice and lubed striker, bolt, etc. on the guage what does the psi read when u have air in ur marker? the psi should be below 400!! also what happens when u shoot ur marker? OK so u cock it back. pull the trigger, the bolt striker goes forward and the striker hits the valve pin. NOW does the bolt just stop dead? does it make the sound like ur guns out of air? more info would be appreciated

__________________

dirtrider54

well when I shoot the gun I get close to 3 shots off then it stops dead. The psi on the gauge is reading i think over 500. I'm using co2 well thx.

__________________
Orange to black 2k2 intimidator with ups

HK ARMY 4 LIFE

20bps_tes

ok man, turn the psi down under 400 u should be good to go

ps. does ur co2 tank have an astisyphon kit install in it? if u don't invest in one.

__________________

Hobo_Joe

Drop that right down.. dont know about the TES but my T1 is at 250... what u running at 20bps_tes?

__________________
Marker = Dragun "The One". #19

=-if you followed these instructions you do so at your own risk, Hobo_Joe, the author takes no responsability for your stupidity in listening to ppl on the internet

Please rate my T1

20bps_tes

i have a t1 too, 230psi,280fps on 6ms. when i had the tessy. 200psi w/ apm bolt and maddman green spring 280fps(feild limit) if ur still runing the stock bolt u will need to have the psi abit higher

__________________

Hobo_Joe

I run at 250psi, stock bolt and stock reg... with the dwell on the standard.
My prob is my fps is all over the show. I have lubed up the reg as best I can, coz I cant open it. When I get a chance to crono I can test it again

__________________
Marker = Dragun "The One". #19

=-if you followed these instructions you do so at your own risk, Hobo_Joe, the author takes no responsability for your stupidity in listening to ppl on the internet

Please rate my T1

dirtrider54

Well I dropped it down to about 250 and its finally working better. thx to everyone

__________________
Orange to black 2k2 intimidator with ups

HK ARMY 4 LIFE