|
Take the frame off,
Take the screws out that hold the stock switch in.
I removed the solonoid, some say you dont need to but if you do be VERY gentel... lift the bottom and walk it out. Then pull the switch out and take the solder off the wires using a soldering iron.
Solder the wires to the new switch and put it where the old one was.
Putting the soloniod back in can be a *****... you need to get all the tubes and wires in the right place or it wont go in... again walk it back in...
Thats a basic Idea
__________________
Marker = Dragun "The One". #19
=-if you followed these instructions you do so at your own risk, Hobo_Joe, the author takes no responsability for your stupidity in listening to ppl on the internet
Please rate my T1
|
!!!!!!!!!help with microswitch!!!!!!!!!!
!!!!!!!!!help with microswitch!!!!!!!!!!
