Thread Tools

**pbpro115** · April 4th, 07:48 PM

How do i get the trigger pin out, and how do i put it back in, the guy at my shop said i can mess up the roller barings if i do this wrong.

**imprez55** · April 4th, 08:24 PM

you have to take a pin tool (i think thats what they are called) with a correct size and line it up to the side without like a star-ish pattern ( the correct side is sometimes indented from the body) pound that through and your trigger is free. once you are done pretty much do the same thing to get it back in. i guess you could screw up the ball bearings, only if you screwed up taking it out royally

EDIT: somtimes you may want to put somthing over the pin when taking out or putting in because you may scratch the pin with just the tool (because the are usually metal)

**Darkpaintball** · April 4th, 08:51 PM

u dont even need a pin tool, take an allen wrench of approximately the same size and set it on it and just tap on it till the pin comes out..thats what i did and it worked fine

**pbpro115** · April 5th, 08:38 AM

tapping it....more like pounding it, that thing was in their

**imprez55** · April 5th, 02:22 PM

thats y i said to maby put somthing on the pin because last time i did that (with my spyder) i screwed up the pin and a little around it

**Darkpaintball** · April 5th, 02:50 PM

did ya get everything installed ok?

Thread Tools

View more Paintball photos