Shiner74

Whenever I attempt to fire my rail the macro flies out from the asa. I don't know if it's some sort of pressure problem or what? Any suggestions or advice would help.

tlmiller

Either the macro is worn and the fitting can't hold onto it, or the oring in the fitting is shot.

Try trimming 1/8" off the macro if it's long enough and put it back in. If it still happens, you can replace the oring, but I personally just replace the fitting because it's easier.

__________________

Shiner74

Alright thanks...It shot fine when I chronoed it in. Then I could here a leak around the bolt. So I pulled the bolt out and made sure the orings were all good. Then I sat my gun down and walked off about 2 min later. It sounds like a bomb went off the macro line blew off from the fitting in the asa. Now everytime I plug the tank off it pops the line again. I'm positive it's not the tank because I used it on someones gun sense mine was mia. I'm going to try to trim it.

Shiner74

Alright trimming = no work what type of fitting is it called. Assuming it can be ordered on AV. And how exactly do you get it out of the asa, I tried pliers with no luck.

tlmiller

It's a straight macro fitting. Should have a allen key hole on the inside, insert the allen key in it, and unscrew (not sure what size). AV probably sells them, I love the colored ones that macrolineguy.com sells. I wanna get a few of the blue ones to match my markers.

__________________