Thanks much for any help,
what i mean about all over it? well when i tried to chrono it getting ready for a 24 hr scenario i found out that it was hard as hell to get a constant speed, i started with the normal setting on the lpr (all the way in then 2 1/2 turns out. I could not get it to be consistent at all, i goes from 280 to 240 then back up and down, sometimes getting in the the lows 180. I had the shop tech take apart the lpr and check all the ring and lub it, still no change. Did the entire rebuild with proto rebuild kit before the posting and still the same. change several bateries, still the same, but i will try it one more time. Now i am noticing if i increase the pressure on the reg a little more it starts leaking really slow, my guess from the noid. I notice the voltage that is stamped on the noid, do you know if thats the voltage that the bat or board is supposed to put out, cause if thats the case mine is bad, only putting out like 2V to the noid with every triger pull.