Thread Tools

**BC_paintballa** · June 23rd, 07:10 PM

hey, im thinking about getting a matrix. i was wondering if they are hard to maintain, because i hear alot of people saying their o-rings bust. Should i just get an ebladed cocker?

**DaBluedevil** · June 23rd, 07:26 PM

Dye LCD matrix, slick honey lube it every other time you go and your good to go.

(I have an e-orracle, currently saving for a dye matrix project, just fyi)

**BC_paintballa** · June 24th, 10:35 AM

is it like hell getting the bolt out to lube?

**BALLER619** · June 24th, 01:40 PM

No the bolt comes out very easy. You just take the back plug off, then remove the o-ring on the tip of the bolt and push the kit from the front out the back.

**DaBluedevil** · June 24th, 03:56 PM

I didn't have to take off that oring, mine just slid right out.

**BALLER619** · June 24th, 04:26 PM

Yea you might not have too, but its recommended.

**bunkertime** · June 24th, 10:47 PM

It's recomended so you don't pull on the plunger and Break something. I've had my Trix for a while and shot over 20 Cases through it over the past few turneys w/ it. And the ONLY o-ring i havee had leak on me was one on my soda can and it was my fault for accudenrtly chipping it.

Trix's are uber reliable, and arn't hard to take care of at all, the botl assembly is VERY easy to clean and lube, I was scared at first when i saw the pics of them pulled apart, but when u do it for the 1st time, it's VERY simple. It all comes out in 1 peice.

Trix > cocker

**BALLER619** · June 24th, 11:18 PM

Yea I just started using my trix a lot and I'm always hoping it works fine and it always does. I always hear people saying how unreliable they are and how they always mess up. I'm still waiting for that day. Hopefully that day doesn't come.

**chronic** · June 28th, 12:05 AM

can someone pm me a detailed version of how to clean a trix since I will most likely buy one tomorrow.

Thread Tools

View more Paintball photos