Originally Posted by Nicky T

Okey-dokey; here's what's happenned:

You have inadvertently put your marker into the "test" mode that we use here at Eclipse to check that the circuit board is fully functioning. To get out of test mode follow these steps:

- Disconnect the battery pack.
- Ensure that your micro-switch is plugged into your circuit board.
- Connect the battery pack
- Turn the board on and it will start going through the light sequence.
- Pull the trigger EXACTLY five times before the bottom LED finishes its cycle and then wait.
- If you have done it correctly the LEDs will flash white quickly and you'll be back to normal.

Nicky T