Thread Tools

**cb_neosythe** · October 31st, 10:36 PM

how many shots should i get off a battery in a basic eforce gun, also what does the rechargable one look completely green that comes with it, or what. I also wonna know if a basic rechargable engizer will work with the charger port. anyways my gun is kinda funky, is it normal when it is near low for it to not shoot only a few times. like the sear is being released.

**SEFishy** · November 1st, 03:44 PM

i get a good 10,000 shots out of it before the click,shoot,click,shoot problem happens. any ni-mh battery will work fine. ni-cad will work to but u must recharge them in there own charger outside of the gun

**cb_neosythe** · November 1st, 07:17 PM

ok well is it normal for the light to flash when i'm shooting fast.

**Pr0ph3t** · November 1st, 08:09 PM

Don't go with a Ni-Cad battery, they form a memory that NiMh batteries don't form.

***onesikpup*** · November 1st, 09:06 PM

Quote:

Originally Posted by cb_neosythe

ok well is it normal for the light to flash when i'm shooting fast.

i dont know, im not looking at the light when im shooting. but mine does sometimes after im shoot.

**crazycupcake** · November 1st, 09:17 PM

no, it means the battery is low.
dont use that rechargeable battery after half a year, it only lasts for like 500 shots. use regular good energized 9vlts.

**SEFishy** · November 2nd, 11:00 AM

ni-cads work fine, their memory is a good thing, its used so that it wont lose its power over time like a ni-mh. so its nice to ahve one charged up and ready to go as a back up

**Pr0ph3t** · November 2nd, 05:45 PM

The memory is a bad thing...if you always charge it at 40% empty or so, it will start getting a memory that that is the lowest it goes...and then you'll only get a 60% charge and it will call it full.

***onesikpup*** · November 2nd, 05:54 PM

thats when you put a "bulldog" on it.....it clears the memory and drains the battery completely.

**cb_neosythe** · November 4th, 08:12 PM

hey here's the thing i'll put a battery on it and it will start to blink after only a few shots, but they are new and never been used it's really pissing me off.

i had a small problem with the board though, but it still like fired and shot so i though it would be fine, i put the Tourney lock on, when removing the board and trying to get those really frigging small anoying screws in i kinda screwed up and the screw pressed on the board and sparked, i figured it would be screwed up but it still fired, but now i'm not getting anything out of my batterys and the battery that came with it isn't charging i'm a little scared i never get to use my baby fully again.

**crazycupcake** · November 4th, 08:47 PM

if you did physical damage on the board, that could make your warranty unuseable. Just to be sure, send it in to PMI with a note saying what problems your getting.

**cb_neosythe** · November 4th, 08:59 PM

alright

**SEFishy** · November 4th, 09:37 PM

ahh maybe its the differnt voltage of the battery?

**cb_neosythe** · November 5th, 07:20 AM

what do you mean? i put 9v in, that's what it said it needed, they where cheap brand but work on my hopper so i thought no big deal.

**SEFishy** · November 5th, 03:19 PM

yes it says its 9v. but read the fine print. some cheap rechargables i have seen as low as 8.4v

**cb_neosythe** · November 6th, 01:14 AM

ah so get a good quality rechargable of actual 9v, cuzz this green ****ty one it came with is 8.4 v

**SEFishy** · November 6th, 08:48 AM

well it will say what teh voltage really is in small print on the side of any battery. i know i have to have a full 9v for my rebel. or the battery indicater is really low, cause my rechargeable is only 8.6v

Thread Tools

View more Paintball photos