evolkers2003

How to lube the quest

FEP info:

Mailing address:

First Endeavor Paintball, Inc.
1601 Pacific Ave. #204
Oxnard, CA 93033

Phone: 805 - 487 - 5297
Fax: 805 - 487 - 5462
email: info@firstendeavorpaintball.com

Website

Q: How fast is the gun?
A: The Quest wont be as fast as many other high end guns, but it will still shoot fast. The stock solenoid is capped at about 23 BPS.

Q: Is it heavy?
A: 2 lbs 3 oz w/ barrel

Q: What kind of barrel threads?
A: Cocker threads

Q: What kind of board does it have?
A: Stock board has NXL, PSP, ramping and semi auto.

Q: What should i expect for air efficiency?
A: Expect to get about 1400 shots off of a cool 68/4500 psi fill.

Q: How does the Quest operate?
A: Electro-pneumatic

Q: What kind of eye sensor is it?
A: Break beam

Q: Can i use CO2?
A: NOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOO OOOO. Compressed air/nitrogen only!

Q: Whats the operating pressure?
A: About 220 psi

Q: What size is the stock barrel?
A: .696

Q: What type of lube should i use?
A: Hater sauce on the o-rings.

Q: Whats the warranty like on my Quest?
A: FEP covers everything except batterys, o-rings, and seals for 1 year. The solenoid has a 30 day warranty. If you are going to send it in you need a proof of purchase and RMA number to be accepted. You have to pay all shipping costs. Any gun is at their discretion to whether they want to fix it or not.

__________________

Sex on tv cant hurt unless you fall off.

evolkers2003

Step 1: Turn your HPA in about 3 turns past flush on the bottom of the regulator housing.

Step 2: Turn the LPR in until the marker begins to fire then stop shooting,

Step 3: Turn the LPR in a half to a quarter turn more.

Step 4: Take the GUn to the chrono. Just change the HPR to affect velocity.

Step 5: Once again, go "gat gat gat" and shoot some newblets.




Make sure to wipe the dow 55 off your bolt after every day of play, and put new dow 55 on it. If there is a leak check the outer bolt o-rings first, and then move onto the pin o-rings. If leaking persists, make sure the LPR isnt set too high, and also the solenoid is ok. After a few days of play, take apart you HPR and LPR and reclean the pistons.


-Demonstration mode: Allows the gun to be fired with out paint. It should not be used to fire paint because there is a very good chance the gun will chop. If this mode is on the LED should be solid blue.

-Anti bolt stick: Adds additional dwell time. It increases the dwell for the first couple of shots after the gun has been not used for more than 15 seconds. This helps keep first shot drop off to a minimum.

-Anti-mechanical bounce: Helps adjust the bounciness of a gun, so extra shots are not added to the gun when firing.

-Loader Delay: Adjusts the amount of time the eyes will read a ball before firing the gun. Useful for adjusting the gun to the hopper.

-Dwell: The amount of time the solenoid is open during each marker cycle. The default setting is 8 in the gun stock, but can be adjusted to prevent drop off and such stuff as that.

-Max rate of fire: How fast the gun can go. Settings are from 1 - 10. Here is a little thing to help adjust your MROF:

setting 1: uncapped
2: 14
3: 15
4: 16
5: 17
6: 18
7: 19
8: 20
9: 21
10: 22

-Firing modes:

Setting 1: Semi auto
Setting 2: PSP mode
Setting 3: NXL mode
Setting 5-20: This sets the ramping. For example, if you set it to 10, this means you have to pull the trigger at least 10 times per second to keep the ramping up.

Stock settings and LED colors:

Red: Dwell, stock setting is 8.
White: Anti-mechanical bounce. Stock is 2
Blue: Trigger sensitivity. Stock is 10
Green: Loader delay. Stock is 1
Teal: Anti bolt stick. Stock is 7ms
Purple: Max ate of fire. Stock is 1
Yellow: Firing mode. Stock is 1.

__________________

Sex on tv cant hurt unless you fall off.

evolkers2003

Warning!!! Make sure you battery is installed correctly! Make sure the battery is placed in properly other wise the battery may put pressure on your on/off switch and cause it to bend or not work. Make sure the battery is placed along the side of the grip frame that runs closest to the trigger!




Me nor any one else on PBF is responsible for any damage to your gun that is caused by taking our advice.

This is also a good place to post small questions that might not need a whole new thread. Also if any info i have is wrong let me know or tell me if any thing should be added.

__________________

Sex on tv cant hurt unless you fall off.

Kleivonen

Bold means wrong.

The stock barrel was .690, but people complained ti was too small so they started making them stock with .696

Also the Dow 55 was a typo. They recommend Hater Sauce to be used with their marker.



I would also be specific as to which board you are talking about, the stock board has changed 3 times.

__________________
KyleLeivonenPhoto

Cold Fusion//||\\8=D Factory

Gearbag Sale

evolkers2003

Ok, i was taking a lot of this from the manual. Im guessing for a board its the original.

__________________

Sex on tv cant hurt unless you fall off.