Looking at buying a new tank (the one I have is a 92/45 much to big). It says in the mannual that the quest can get about 1500 off a 68/45, but I'm thinking this is going to be a little on the high side.
I've found Quests to be all over the place. I believe some people actually achieved higher than that, but most people do not get as high as 1500 I think. With some tuning and after it breaks in a little (if it isn't already) you should probably be able to expect somewhere in the region of 1400.
i know this isnt a scientific reading but from the same crossfire tank i get 100-200 more shots on the quest than i do my shocker.
Also my friend has the same tank and shoots about 300 shots less on his ion.
It has good air efficiency because it requires less energy from the low pressure regulator than the standard or what is on most markers.
So even though the operating pressure is 210 psi you will see it shooting better than some as low as 180 psi and so on.
__________________
kenny is no doubt my new best friend
Kaz is also a cool guy.
A little high!!! lol try double what it should be. thats why your only getting lightly better than the shocker or Ion. lol.
The other week I accidently tested my max with a 45/45. I didn't fill between games and was getting major shotdown at about 900 balls off the tank. I Still shot someone with it though, lol freaking amazing it did 900 off a 45/45 though.
My cousin had his running at around 70, drop it down to 90 and slowly drop it till the bolt stops cycling fully, then bump it back up till it does cycle fully.
__________________
If you believe in God, and are proud of it, put this in your sig.
46% of teens engage in pre-marital sex. 89% drink before the age of 21. Put this in your sig if you think that pandas are the chillest animal alive
My pm6 is getting around 750-800 horridly tuned and stock.
BS cheak your numbers, no way a pm6 is getting that good. I've seen one get only 1000-1100 off a 68/45 with a tophat mod and tuned proberly.
Anyway, andy your lpr (which is what the quest gauge is for!! Not for the HPR!) should be only at about 100 to 80 psi. Turn your lpr so it reads this and leave it alone. Your quest will shoot beautiful at this level. What kenny is telling you to do will fine the minium psi your quest can run at, but I don't suggest doing this because it could lead to more problems and it sounds like your not used to the gun yet, so leave it alone for the time being.
.... I've never seen it.... I don't know what the weather is like in Vargina, but in Wisconsin I've never seen a pm6 get anything like that in the cold and rainy or hot and humid weather.
Quest air efficiency??
