jtpaintballer31

first i started to sand the feedneck arrgghh 10 min later im burnin it with a lighter and cuttin the melted part off with my dads case knife so that goes on for about 10 min then here comes the good part 30 sec with a saw x to the z xzibit ya it only to me 30 frickin secs to do the job sandin would have took me hours but i did smooth it down with a very fine grit sandpaper.so this is for all you fellas with an egg USE AN F'ING SAW! and shut the f up with all these threads use some common sense and go with the fastest way that works.

RB

If your just cutting the feedneck down, its no problem, most people would use a saw. Burning it...thats just retarded, n2m the smell of burnt plastic is enuff to make me puke. If your sanding it down diameter i wouldent recoment using a saw.

-RB-

__________________

Stroked and Sprayed '94 Fobra

-=[SpLaT]=-kInG

Yea I've never herd of anyone burning their hopper but whatever. Obviously most people do use a saw to cut down their feedneck but you can't saw it down to fit into the markers feedneck you have to sand it. I save myself all that time and I just buy a clamping feedneck.

__________________
Team Razors Edge
"I am an artist please don't wipe my paint until you show it to a ref"

Gangsta_Redneck

i hear that if u saw the feedneck it will feed faster and i kno for a fact that it gives it a low profile and it is less of a target

__________________

Pm6 werd..

DarkTamer

It won't feed faster... if anything, it will feed slower.

Anyways, I hope you realized that burning plastic emits toxic gases, even for hours after thep plastic stops burning

__________________