Cockerkid63

What should my gun pressure be for my B2k4? 300? I dont want to blow my noid here guys. Please help.

__________________

bobide

220-250psi for hpr i think.

Back the lpr out all the way and increase till it cocks. Then i think a 1/4 turn and u'll be good. Think lpr runs around 90psi, maybe more.

__________________
05 PROMASTER , 14" Macdev Matchstick, Kila Drive, Zentriam Valve, ICDU ram, CCM no-rise, Sonic lpr

Cockerkid63

Is that what my guage should say? 220-250? And i dont know if my tank is hp or lp. I have a 48/3000 Pure energy tank (yeah i know i need a bigger one).

__________________

L1nUx_r0ot

your HPR gauge should say between 220 and 250. and it shouldn't matter which type of tank you're using because both HP(800psi) and LP(450psi) are above 250 psi meaning they'll supply enough air pressure.

__________________

sNoW PIrAnHa

I have my pressure around 200 but it can go all the way to 275 and still be fine. It depends on the dwell and stuff. If you have a low dwell then you must raise your inline pressure, if you have a high dwell you must lower your inline pressure.

The solenoid vents itself at like 95-100psi. In the manual it tells you to screw in the LPR until the noid leaks like a *****, then back it off a half turn, that will be incredibly high and unneeded. 3/4 of a turn past cocking is fine.

Also if you have a lightened hammer you will need to either get a new lighter valve spring, raise the dwell or raise the LPR. Because if the pressure is too low to push the cupseal back it can be trouble and you won't have smooth shots.

__________________
"I have no mercy or compassion in me for a society that will crush people, and then penalize them for not being able to stand up to the weight"- Malcom X