Mangobutter

ok i have a b2k4 the first reg is suppose to be set at around 250-300 psi, i can adjust and see that by the gaudge, the second regulator is under the barrel but i have no clue what psi its suppose to be at or how to see what psi it is when im adjusting it. im dig through the manual but at first glance i did not see anything, if any one could help me out it would be nice =P thanks

__________________

MP11

To get better answers I would have posted this in the ICD Forum. I do not know a lot about Bushmasters, but as with most guns thesecondary reg is a LPR (Low Pressure Reg). It adjusts how much PSI is used for the marker to cock. If you set it to low you will have problems, if you set it to high you might blow out your soleniod. I know that with Matrix's before their was an LPR for them, the bolt used the same amount of PSI used to cock the gun, as their was used for the marker itself to cycle (valve and what-not). Turn your LPR down all the way untill it can barely cycle, then increase by a quater turn untill it can shoot paint.

-Mike

__________________

sNoW PIrAnHa

Yea do what mike said. Set the inline so its shooting 280 fps then unscrew the LPR until it doesnt cock, then screw it in until it does plus a quarter turn.

btw this was mentioned in my sticky in the ICD section.

__________________
"I have no mercy or compassion in me for a society that will crush people, and then penalize them for not being able to stand up to the weight"- Malcom X

Mangobutter

ok thank you

(sorry for not cheaking the sticky)

__________________