Thread Tools

chrisw91 · January 16th, 07:23 PM

ok, i have a vs1 run co2 and for some reason when i shoot a ball it does a dry fire right after the ball. its like a 2 round burst or sumthing. but doesnt shoot 2 balls. it seemed like this happened mostly when im aiming up slightly. could my velocity be too high? also after i ran out of balls i dry fired fast like 5 or 6 times and it just started firing on its own. like it had fully auto. it didnt stop till i turned it off. any ideas? thanks

TheAznInvazn · January 16th, 09:44 PM

bad board?

chrisw91 · January 16th, 10:32 PM

well its brand new. but i adjusted the velosity and it doesnt seem to be duing it anymore. could that have had something to do with it? maybe the parts couldnt move as fast as the velocity wanted it to? idk thanks

TheAznInvazn · January 16th, 10:37 PM

Maybe you're pressure was too high or something, but velocity has nothing to do with parst moving faster IMO. Just a thought.

chrisw91 · January 16th, 10:54 PM

hmm, ok thanks

**txaggie08** · January 19th, 01:25 AM

Could have been having trouble re-cocking against the spring. It also could have been an issue with the valve. It sounds to me like maybe you had an o-ring that wasn't quite seating right.

If it quit, that's that. Usually I recommend to anyone having EBB troubles like that to oil everything well, clean everything well, and dry fire it a good bit. 99% of the time that makes the issue stop..

chrisw91 · January 19th, 05:54 PM

hmm, i dont kno cause i went paintballing today and it was doing it again, then i turned the velocity down and it didnt do it again.

Thread Tools

View more Paintball photos