Thread Tools

**Crimins** · July 26th, 07:59 PM

Well a few months ago I got the Spyder Victor and a few friends were telling me to stick with the gun and upgrade. The two things he told me that I should get was a low pressure vacuum chamber and an air chamber assembly. Also I been thinking bout upgrading to a 21" barrel but everyone has told me it would just get in the way.

**<YamahaRaptor>** · July 26th, 08:02 PM

DONT GET ANY THING LONGER THAN 16inches. And i personaly think that you should just save your money on a new gun or a ESP frame.

**LuckXIII** · July 26th, 08:08 PM

21" woah unless your planning to mill your gun into a machine gun i'd say stick to a 12" or 14", i personally say get barrel (try not to go over 40), get a regulator (dont be too cheap about this), drop forward with on/off (there all the same really, dont need anything too fancy) then maybe electro hopper (unless you want this as your #2 upgrade if you break balls often) after this prob save up for 200-300dollar gun and just move over everything but the barrel

**Ryan_Page** · July 26th, 08:17 PM

put this in the kingman forum, fiki will learn you. you should get an esp frame, an electro hopper, and a 12" or 14" barrel, 14" is where accuracy and velocity cap off, and make sure the porting doesent go under the 1st 8"s of the barrel, it lets out co2/n2 early. a good cheap one is the Smart Parts Progressive, or for cooler porting, Teardrop, both are the same in accuracy, or a J&J Ceramic is good, for a hopper, get a empire reloader, ricochet apache, or halo b, or viewloader evlution 2. as for the esp frame, i dont know any, i dont own a spyder, you might also want to buy a new bolt, the best for that is the aka lightning bolt.

**LuckXIII** · July 26th, 08:46 PM

dunno, bolt and esp frame seem too 'spyder specific' and for the cost of nearly 80-100 bucks just for those two i rather just get either a new gun (cocker or electro) or if your really happygolucky for spyders get The One cant go wrong with 20-40bps