flame575

I'm havin' an issue with my marker. When I screw in my CO2 tank, CO2 starts spraying out of the end of my barrel. Does anyone know what might be causing this and/or how I can fix the problem?(don't say something like "buy a new marker")For the record, I have already tried little things, such as making sure all my screws and such are tight, put new o-rings on, and made sure everything was just put together right and there were no little...cracks that he CO2 could be leaking out of.

If it helps, my marker is a Spyder King.

Thanks ahead of time!


~Randy~

Huey69

Your cupseal is bad...replace it..
Post this in the spyder forum next time.

__________________
Taking a break....teamless for now

LookOverThere

Wrong forum..

And its probly your cupseal.

flame575

Thanks much, and uh, sorry about the wrong forum thing. As you can tell though, I'm obviously new, but I'll figure it out. Thanks again.

dabomb323

definitely the cupseal or cupseal spring, same thing happened 2 me, sux dont it?

__________________
Now I lay me down to rest, My paintball gun upon my chest. If I die before I wake, My paintball gun is all I take.

P8ntSniper17

Make sure that u havent alredy cocked the gun and also make sure that none of the o-rings are broken go to your PMI maneull if that doesnt work

wyand

I would replace the cupseal, and your O-rings, just for good measure. This way, you've replaced all the seals in one shot, and u can remember the date that you did it..
Not that it matters a whole lot. I just try to replace mine every 3 months or so. Theyre cheap.. and easy to replace.

__________________
USMC 0861/0321

[img]

spyshark

As everyone else said probably cup seal a five minute fix.Don't pull the valve out unless you have to .You won't need to to change the cup seal.

__________________