Thread Tools

**HeadyNugz** · August 5th, 01:35 PM

OK, so I have the 50g switch and the magnets to do the trigger mods. I'm also gonna sand down the trigger to a blade. But I can not get the damn trigger pin out of the frame. I used a thin enough nail and a hammer but the damn pin wouldn't budge. The friggin nail was actually bending.

If anyone have any suggestions they would be much appreciated.

**LookOverThere** · August 5th, 01:36 PM

Dont hit the side with the ridges. Or hit it like a man.

**HeadyNugz** · August 5th, 01:47 PM

Well, I started off by hitting the side thats not on the on/off switch side because i thought that was the one with out the ridges and it was recessed a bit. Then, after that side didnt work I tried the other side. Neither side budged at all. And I was hitting hard enough to bend a nail.

I didn't think that it was supposed to be that hard to get that stupid thing out.

**tmaxx_2.5** · August 5th, 01:52 PM

hit it harder

**DixonNxn** · August 5th, 03:28 PM

hit the opposite side of where the ridges are....get a sturdier nail too

**LookOverThere** · August 5th, 03:37 PM

yeah those little ***** nails dont do nothing, Ill even video tape howto do it if you still cant figure it out.

**HeadyNugz** · August 5th, 09:56 PM

Ok, I just tried it again. I ended up breaking an alan wrench in the process. Still no success. I can't imagine that I'm not hitting it hard enough since I cracked an alan wrench in half. This is really starting to piss me off!!!!

**CmaN3** · August 5th, 10:14 PM

Wow, i think your trigger frame is defective, i got mine out by using an alan wrench, and hitting it with a screw driver. Your frame is messed up dude.

**outlaner_0990** · August 5th, 10:15 PM

you should hit it on the side opposite of the on/off switch. you do have to hit it VERY hard. just keep trying.

pbextremer · August 5th, 10:31 PM

than how do you hit it that hard to get it back in?

**[^_^x]** · August 6th, 07:47 AM

I use a cut q tip for the thick ones and a toothpick for the skinny ones. Maybe your doing it on the wrong side. You dont have to hit it that hard. a few taps gets them out just fine. I uses a cup as a hammer too...lol. I was to lazy to go get the tools.

**HeadyNugz** · August 6th, 05:19 PM

Got It.

pbextremer · August 6th, 05:50 PM

how did you get it back in?

Thread Tools

View more Paintball photos