Thread Tools

**MiniMePeoN** · August 8th, 04:46 PM

My TL-X's velocity is tuned to the highest fps its supposed to be able to get too . But my gun is only shooting 250-275 its not really being very accurate because it is arc'ing to early. I ordered a 32 degrees spring kit and im hoping this fixes my problem , but just in case , does anyone else know any other problems wrong with my gun? I just oiled it too.

**<YamahaRaptor>** · August 8th, 04:52 PM

250-275 is the perfect FPS. Don't go over 300 fps

**HuNtS** · August 8th, 05:05 PM

your spring might just be worn, try stretching it a bit, or just get a new spring...

**outlaner_0990** · August 8th, 05:42 PM

like the boy said, 275 is about right. most fields are at 280 for their limit.

**MiniMePeoN** · August 8th, 06:44 PM

hmm , well thanks but there was another reason , i still would like to know why its shooting so low , i could reach like 310 but now i cant ( no reason why i would want to just making a point ) .

**<YamahaRaptor>** · August 8th, 06:51 PM

After a while from shooting the spring gets looser and looser. Also i don't know if you know but the knob in the back controls the velocity.

**MiniMePeoN** · August 8th, 06:55 PM

yes .... i went through that i set it to the max it could go on my first post.. and for the springs ill wait till my 32 degrees spring kit gets here install it and try to see if it works thx all

**KidPaintball** · August 8th, 08:58 PM

Bad paint to barrel match I say... The paint sounds too small so it not geting enough of a push. Just sounds like that to me.

**stupidlikeaf0x** · August 8th, 10:06 PM

With some higher flow home mods, you could raise the fps without a new spring. A heavier main spring means that your gun will have more kick. I'd suggest drilling out the VA and the valve and removing the venturi from the bolt. That should get you a lot higher.

Thread Tools

View more Paintball photos