darren-r

im working on my friends spyder Xtra (my old one), and when i took out the valve it shot out and im not sure which way it goes in. does the bigger hole or hte smaller hole go on the cupseal. and does it matter where the screw that holds it in place goes? because theres 2 same sized holes on the side.

usually i would know this, but havnt worked on a stacked tube in a while.
thanks

__________________

darren-r

ok, i found out the big hole is where the cupseal goes, because of markings left on the valve from that bar that holds it in.

__________________

[^_^x]

theres also a video on the kingman site.

__________________


Dragun "The One"
Black/Green Fade
Dye Excel Barrel 14"
Halo B w/ Rip Drive
1337 Remote Control Setup (Limited Time only).....

32 Degrees Rebel 02 Electronic Vertical
Black
Dragun Stock Barrel 12"
Gravity Fed Hopper

n00b Gun Package Under $90