Joshh100

I just bought and installed a CIP sweet spot trigger on my imagine select as well as a 50g switch and I love the combo! However, the trigger does not return to one specific spot, it just kind of swings freely on the trigger frame. There is no spring on the trigger because I read the stock trigger spring did not fit this trigger well and it wasnt really needed so I just kept it out. Is there any way to get the trigger to return to a specific point, rather than wherever my fingers stop it? thanks in advance..

spyderpaintster

the same thing hapened to me, so all i did was shorten the trigger pull with a new screw on the trigger so it rested against the clicker. It was still a little loose but it fired faster.

__________________
2k3 vision impy with:
Halo B,Smart Parts Lpr, Planet Eclipse blade trigger, Smart Parts Low Rise Twist Feed, Dye Stick 3s ,Nu Designz Ram Housing, Hammer and, Slick Shot Shaft Voodoo Bolt, Vertical Max FLow, 68/3000 nitro

soon to come: pipe kit

Zeruel

You could try the magnetic trigger mod. It is listed in the stickies( i think). But since noone reads them , ill outline it for you. First, you need to buy a pair of magnets. You can get these at radioshack. You then need to drill out the front screw hole a little so that the magnets will fit in. You can then superglue the magnets in place. I have tried my friends imagine with the magnetic and regular springs. The magnetic has a nice snappy pull. I think you will like them. If you need more info check the stickies or ottersccustoms.com for the full guide.

Hope that helps

Destructo6

The upper setscrew limits forward travel, just like on the stock trigger. Take off the frame, turn the screw counter clockwise and fit to the body. Repeat until you get it where you like (a paper's thickness from the button is good).

__________________
God gave you a soul.
Your parents, a body.
Your country, a rifle.

Keep all of them clean.

pimpin balla

yeah man i got screwed w/ that combo 2. What i did was put a piece of paper under the trigger and tape it w/ some electrical tape then put the grips over the tape. heres a pic of it. (if you can tell)

Attached Images

Gun 003.jpg (20.2 KB, 11 views)

pimpin balla

sorry i couldnt get a better pic that is the only one i had cuz my dad has my camera in chicago w/ him