tyson171

Hey everyone, my little brother has a spyder victor 2 to (only had it for a couple of months), and it doesn'thave hardly any pressure to shoot a ball out of the barrel( lobes a ball about 5 feet). The tank is full, and i tried other tanks as well. I also replaced the cup seal, and took the gun completely apart to make sure air was flowing through all of the valve and lines all the way down to the asa. The strange thing is, when i shoot, i feel a lot of co2 under the trigger on my hand. I also started to shoot the gun really fast, and right around the trigger the gun got extremely cold, and frost began to build up around that area. Two weekends ago the pin that holds the striker to the bolt came out, and i tightened it back up, but since then the gun just hasn't been shooting right. Any suggestions would be great, and the gun is recocking itself, there just isn't hardly any velocity. Thx for your time.

Tyson171

HU$$$$TL3R

did you turn up the velocity?

__________________
Hello kiddies

big_balla

Air is shooting out by the trigger? That doesn't even make sense. When the pin fell out, maybe you lost a part? That sounds very odd. Even if the velocity is low, the trigger shouldn't get cold from shooting. Double check that you have all your parts, but I really don't have an answer for you. That's really weird, though.

__________________

paintballguy20

thats not all that weird. the same thing happens when you put too much oil in a gun. sometimes the oil will come out by the trigger. i could be wrong, but could something be wrong with the sear or striker or any other part in that area of the gun? is it possible that if the oring came off of the striker, could cause it? hope this helps(maybe). hope you can get it fixed.

paintballguy20

spyshark

Could be several things,get the manual out and tear the gun aprt and put back together and check o rings lube evrything.Did you pull the valve body out or just the valve pin?Make sure you are not missing anything.When in doubt take it to the shop.

__________________

tyson171

Well....i fixed it the other day....my little brother messed with it, and when the pin came off of the bolt....he put it in upside down....i never noticed it until i pulled it apart just the other day...lol so an upside down bolt will cause that kind of thing to happen(i would have never thought of that, since the gun was still recocking, but eh o well its fixed now.....heh funny how the most obvious thing is always over looked. Thx once again everyone for your help, and now i'm going to go beat my little brother around for that .

spyshark

Just give him a toilet swirly and call it even.

__________________

[^_^x]

u made me miss my vicky 2.

__________________


Dragun "The One"
Black/Green Fade
Dye Excel Barrel 14"
Halo B w/ Rip Drive
1337 Remote Control Setup (Limited Time only).....

32 Degrees Rebel 02 Electronic Vertical
Black
Dragun Stock Barrel 12"
Gravity Fed Hopper

n00b Gun Package Under $90