Thread Tools

**spyder person** · January 25th, 07:23 PM

i have an older right feed spyder and the old style detent shaped somewhat like this[===] and since i have been living in a hole i dont know much about eyes in spyders can i put they eyes on something like that? im pretty sure the breakbeam wont work the right feed takes up the whole right side

**Stan** · January 25th, 09:40 PM

your probobly gunna have to get a vert feed body, cuz with breakbeam, they ahve to drill both sides, and your feed will be in the way, and it just wont work. BUy a new body, itll save you money

**spyder person** · January 25th, 09:45 PM

what about bounce beam?

**bobide** · January 25th, 09:52 PM

bouce could work. T-board also can use bounce.

**spyder person** · January 25th, 10:17 PM

i was wanting a new highrise body anyway

**Stan** · January 26th, 07:27 AM

if u drilled the left side of teh body for bouncebeam, it might work. i've never used a rightfeed, so dont know of its any different.

**tmaxx_2.5** · January 26th, 03:40 PM

i think either would work, just drill your eye holes at the bottom of the top tube where they are supposed to go. The side elbow shouldn't be in the way..

**spyder person** · January 26th, 09:23 PM

ok one more thing i am suppose to drill the eyes at an for bounce beams?

**bobide** · January 26th, 09:32 PM

yes, u must drill it at an angel. Check out the t-board site, i know they have some info on how it looks and how to do it.

**spyder person** · January 26th, 09:43 PM

ok now in finding the spot to drill they eye what would be the best way to determin the right spot?

forgive me for my electronic ignorance i have shot mech untill resently

**bobide** · January 26th, 09:50 PM

like i said. I think scenario dreams website has a chart thing which u can print out and put over the body to help u figure it all out.

Thread Tools

View more Paintball photos