Thread Tools

**Ahmadi6490** · January 31st, 04:50 PM

Quote:

Originally posted by topazbullet
I know the suction mod involves leaving your valve open for the least time possible, so I tried this. I'm not sure if it helps, but it doesnt hurt it.

First, get two strong magnets. I took the two from a Tommy Hilfiger money clip. They fit inside the inside the little window that shows a victor's bolt perfectly. Put one on the back block, one on the bolt so that they attract each other. They should help pull the bolt back to decrease valve dwell time

strong magnets

where magnets go

Hmm, I was thinking the bolt would end of getting stuck and couldn't close to shoot a ball.

**tmaxx_2.5** · January 31st, 04:56 PM

hmm, never seen that before. It might work, but the bolt shouldn't get stuck back, i would think the spring would push on it hard enough. I dunno, try it out and see..

**insaneoaint706** · January 31st, 06:22 PM

if it dies ant thing all it will do is give you a heavier bolt

Thread Tools

View more Paintball photos