Thread Tools

**!nSaNe-ImPy** · June 9th, 03:40 PM

The part of my mask that covers my mouth on my JT Spectra is coming loose and its hard to get it tightend because the other side just turns with the screw! any suggestions?

**Grungydan** · June 9th, 06:38 PM

Is there any way to grip the nut on the other side with some pliers? Maybe needle nose pliers could get ahold of it.

Other than that, you could buy some 2-part epoxy or another good glue, and dab a bit in between the part that's spinning and the mask (make sure you don't fuse the screw to the nut though

), let it dry so that it can't spin anymore, and then tighten it down.

**mehdiballer** · June 9th, 08:01 PM

just get some pliers and hold the other side in place so it doesnt spin.

**!nSaNe-ImPy** · June 10th, 12:32 AM

k thanks

**bunkertime** · June 11th, 09:45 PM

Don't be afraid to Cut or bend the metal to give the Plyers a good flat spot to grip on. Or try a V-force mask

**!nSaNe-ImPy** · June 12th, 11:01 AM

no i like my mask..illl just tighten it with plyers

**A-5_ORdAn** · June 20th, 01:48 PM

You should just get a new mask, save you the trouble.

**!nSaNe-ImPy** · June 20th, 04:40 PM

your ignorant...my mask is thermal and its fine its just a little loose...once i get money ill get invision or proteus but getting a new mask just because of the lose mouth cover that IS NOW tightened........ugh w/e

Thread Tools

View more Paintball photos