I have everything for a spyder clone (3a invinsible power
www.3apaintball.com) But the feedneck on the body is glued in by the manufacture, and now the glue came undone, so the feedneck moves resulting in ball breaks, stuck bolt, moving hopper, etc. (tried to glue it, but not very successfull, and now it has some scratches, marks, and glue spots around feedneck.). I have heard that it can be fixed, but don't quote me on this. Everything else works just fine though. I modded the trigger frame a little. I will part out or sell as a whole.
Also selling the barrel.
http://www.pbnation.com/showthread.p...7#post16223577
Selling:
whole gun w/o ACI barrel=$30-40 or best offer
whole gun w/ACI barrel=$60 or best offer
Also have stock barrel=$5 (one little man. defect, but won't effect preformance, and hardly noticable)
Part Out=offer
(prices not set in stone, so just offer)
trades:
cocker Barrel (perferably a Lapco barrel).
Explaination of trigger/pics.
It is off of a spyder clone (basically the same as a spyder, but the screw holes on the bottom of the frame are regular bolt patterns, not the spyder offset bolt pattern.) It should fit on a regular spyder body. It also has the hopper mod attached to it. Basically this mod, but could easily be converted to your extreme rage hopper.
http://www.airgun.com/downloads/eureka3.pdf
I also added another cable/plug to it (not pictured, because it is inside the grip) for a warp feed or anything else (basically to connect to two different things at once). But if you deside not to use the switch, then you can leave the wires in the grip or melt the hot glue to remove the switch.
Here are the pics.
Not selling the hopper!
***Spyder clone f/s, f/t (buy as whole or part out)***
