Very new to this paintball repair stuff, so all suggestions are appreciated!
The leak is coming directly out of the regulator adjust screw. There is a set screw in there with sharp point but it's leaking straight over it.
Attempted to take apart the expansion chamber and replaced o-rings that I saw. Tried Teflon tape and still the same problem...any thoughts on this??
The marker works great otherwise...some how during my tests it didn't leak one time and shot about 5 balls...then it started leaking again and has not stopped
but if its leaking out that hole... rebuild your regulator with new orings [assuming you can. if its just an expansion chamber, you might want to try wrapping your screw with teflon tape]
but then again, its been years since i've serviced a spyder
ya either, your reg just needs to be rebuilt or you are over/under presurizing it, regulators typically will vent out pressure if you are overemphasizing them and dont have enough pressure to seal properly if you are underpresurizing it
can anyone tell me how to fix a leak on my spyder rodeo it is coming from from the expansion chamber set screw all o rings are replaced and there is no way to take apart the expansion chamber any help would be greatly appreciated
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Paintball Guns and Gear forums
1.4M posts
64.8K members
Since 2001
A forum community dedicated to Competitive Paintball players and enthusiasts. Come join the discussion about paintball markers, goggles, masks, air, stores, and more!