Alpha

I just made a feed for 25 paintballs, and I'm gonna make more for 10, 20 and 15, and I'm thinking of making about 10 ten round tubes.. The way I have it set up is you remove the whole tube from the elbow and put more paint n it. I can't figure out a way to make a ball detent for the back. I might try using some thin rubber or something..

Any ideas?

I'll post pics and steps when I finish them.

__________________

MP11

You could E-Mail CCI asking for one or something of the sort. Good luck.

-Mike

__________________

Alpha

The kind of PVC I have is great for paintball.. I used CPVC, nd I'm not too sure what the difference is.

I already made a blowugn out of it. Abotu 3 feet of it. I can nail a 2" tree right where I'm aiming from about 40 feet away. I did it with teh 10 foot piece when it was togethor and it went pretty far. I was suprised.

MY next project is a PVC paintball marker.

__________________

Javaman

So the inner diameter of the CPVC is pretty close to paintball size? Tight enough to use as a blowgun yet loose enough to feed properly? Sweet coincedence!

__________________
By the time a man realizes that maybe his father was right, he usually has a son who thinks he's wrong.

predator14

a bunch of elbow grease

__________________
And I heard, as it were, the noise of thunder: One of the four beasts saying: "Come and see." And I saw. And behold, a white horse. And his name, that sat on him, was Death. And Hell follwed with him.

Christian

pics yet?

__________________
Christian aka STUDCAKES

lbreevesii

the diff w/ cpvc is that its designed to run cold water but not hot...not sure why they would decide to make diff types other than price...i might have to experiment w/ that sometime...

__________________
member of the COG, TOG, ICDOG, SPOG, IONOG, member #'s 25, 80, 19, 7, and 7.
Founder/Prez of PBA

VIVA LA FIKI!!

Alpha

The ends were a bit toight, and it could've either been becuase my paint is swollen (I have a bag of 500 paint that some renters gave me after a game, and apparently a ball broke in the bag somewhere along the lines.)

So the paint is swollen, and the ends are jagged. I sanded it off and tried a marb.. Works nice. Let me finish up this one and I'll make pics... I wish I had a digital camera or else I'd do it now. My webcam has some software conflict with somethign so when I take pics my coumputer can randomly without warning reboot

__________________

eatbutt

(still on the subject of finding a way to seal the reloader for quick reloads right?)

If i were you i would get an old wine bottle, pop the cork off, then stick it in the PVC.

It wouldn't take more than a second to pop it on and off, and when it gets too worn, just get another one! also, you can go to a science store and buy a bunch of small/exact fitting ones, along with some other cool gadgets lol, like 15 round tubes/viles, unless you made those out of PVC also...
I, too, am a customizer with only 3 tools... PVC pipe | Electrical Tape | Scissors

I, myself think it would look funny, original, and very cool!!! <----not sarcastic
---GL---

jml11220

As to a previous question, one of the main differences between PVC and CPVC ipe is the thickness of the walls. PVC has a much thicker wall and is much heavier as a result. As far as fitting a paintball it is just a matter of the inner diameter being correct.

Scope

hahaha I am definately gonna get a phantom vsc later! Very nice idea Alpha. I would try maybe like a thing of duct tape? Old school to cover the tube.

__________________
Pin, flank, kill. Hooah!