Woodsballa A-5

well, since companys are getting smarter, by adding nice on/off asas that dont need to be replaced, you dont really need to replace a dye stock board when it can shoot just as fast as a virtue board...i rate ppl on the whole set up tank hopper etc

__________________
http://www.paintballforum.com/wtb-th...ml#post2115488
CHECK OUT MY MARKET!

Trbo323

^^^ where did that come from?

__________________

blue to black dm6
hyper 3
top hat mod
laser eyes
CP flow plug
32 degrees drop forward (yes i like my drop forwards)
cp micro on/off asa
deadly winds 14" fibur barrel with full freak
Dye rotor with speed feed
centerflag 68/4500 with on/off

roverboy

ok so lets get back on subject here what do you think about the 2nd gun i showed you???????? and what kind of bolt is this????????

roverboy

here is the bolt it says G-1 on it

Attached Images

	moto_0186.jpg (37.0 KB, 9 views)
	moto_0187.jpg (35.5 KB, 10 views)

tlmiller

That's an odd back for a G-1. usually the backs were heavily milled to reduce weight. G-1 bolt was an aftermarket 2-piece bolt. I personally never used one, but you could get different backs depending on the length (pre2k, post2k, EVO/STO)but use the same front. Other than the fact that every back other than yours I've seen of them (only like 3 still) was heavily milled, they never particularly impressed me over stock as they were still all metal, and so were only slightly lighter due to the milling.

__________________

roverboy

thanks for the info